Equipment preparation guide
Glass Edging Chips: What to Record Before Diagnosis
Record chip locations, glass dimensions, operating changes, wheel and cooling observations so a technician can investigate a glass edging problem.
Record the conditions in which the defect occurs
Chipping can appear on different edges, at different stations or after a format change. Keep photographs, identified sample panels and alarm records, and record how often the defect occurs before discussing the problem with a technician.
Use the same terms for the entry and exit direction, upper and lower surfaces and corner position in every photograph. Include a scale so the location and size are clear.
Information that helps a technician investigate
| Observation | Record |
|---|---|
| Chips on an upper edge, lower edge or corner | Both panel faces, entry and exit direction, exact location and photographs with a scale |
| A particular thickness or size is affected | Material, thickness, dimensions, condition after cutting and affected batch |
| The issue followed a speed or stock-removal change | Previous and current settings, change time and corresponding identified samples |
| Unusual noise, vibration or an alarm also occurred | Alarm text, affected station, time and equipment state |
| A cooling or wheel-related observation | Water-supply observations, wheel use and recent maintenance recorded according to the machine instructions |
These records support diagnosis. A single symptom does not identify a failed component or establish which parameter should be changed.
Keep observations and corrective work separate
For abnormal vibration, breakage or another hazardous condition, follow the machine’s stopping procedure and involve qualified personnel. Internal grinding-head, drive, electrical, interlock and cooling work follows the equipment instructions and site procedures.
Send the model, sample IDs, photographs, alarm details and recent changes to the support contact. A webpage cannot determine a safe adjustment or authorize bypassing a protective device.
Before contacting support
Are photographs enough for a diagnosis?
Photographs are useful, but include the glass specification, affected location, batch, machine configuration and operating records. Link every image and measurement to a sample ID.
Should we assume the wheel is the cause?
Record the wheel and cooling observations along with the other conditions. Ask a technician to review the evidence rather than assigning a cause from one symptom.
Related equipment and documents
Installation and service terms
Review the published installation scope and warranty terms.
Review serviceStandalone double edging machine
Review an edging unit for your existing handling equipment.
View the machineR-corner process requirements
Define radius, edge finish and the selected machine option separately.
Review R-cornersContinue your preparation
Choose a double edging machine or line
Compare BYAA, BYS4525 and a standalone unit against your glass and handling setup.
Read the selection guidePrepare an R-corner sample trial
Define the drawing, representative samples, process conditions and acceptance record.
Read the sample checklistPrepare your factory layout
Map glass flow, utilities, installation access and upstream and downstream interfaces.
Read the layout checklistDiscuss your processing requirements
Send your glass drawing, thickness, panel sizes, required output and existing handling arrangement. We will review the suitable configuration and the information still needed.